Steering
How To Proceed With Troubleshooting
|
HINT:
- Use the following procedures to troubleshoot the power tilt and power telescopic steering column system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
| NEXT |
 |
|
INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
 |
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Check for DTCs.
Click here 
Result | Proceed to |
CAN system DTC is not output |
A |
CAN system DTC is output |
B |
HINT:
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
| B |
 |
GO TO CAN COMMUNICATION SYSTEM |
| A |
 |
|
CHECK FOR DTCs*
(a) Check for DTCs.
Click here 
Result | Proceed to |
DTCs are not output |
A |
DTCs are output |
B |
| B |
 |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
| A |
 |
|
PROBLEM SYMPTOMS TABLE
Result | Proceed to |
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
| B |
 |
GO TO STEP 7 |
| A |
 |
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Terminals of ECU.
Click here 
(b) Data List/Active Test.
Click here 
| NEXT |
 |
|
REPAIR
| NEXT |
 |
|
CONFIRMATION TEST
| NEXT |
 |
END |
|
Was this page helpful?