Steering
IG Power Source Circuit
DESCRIPTION
When the ignition switch is turned to on, the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
The multiplex tilt and telescopic ECU also receives ignition switch signals via this circuit.
WIRING DIAGRAM
HINT:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
(a) Disconnect the J174 multiplex tilt and telescopic ECU connector. |
 |
*a |
Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
|
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
J174-10 (IG) - Body ground |
Ignition switch ON |
11 to 14 V |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
(a) Disconnect the J174 multiplex tilt and telescopic ECU connector. |
 |
*a |
Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J174-1 (GND) - Body ground |
Always |
Below 1 Ω |
J174-8 (GND2) - Body ground |
Always |
Below 1 Ω |
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?