Engine, Hybrid System

Efi Relay

~1min read

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE INTEGRATION RELAY

2. INSPECT INTEGRATION RELAY (EFI)

NOTICE:

  • Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.
  • The internal circuit of the integration relay is as shown in the illustration below. Inspect the integration relay using the following procedures.

(a) Measure the resistance of the EFI No. 1 fuse.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

EFI NO. 1 fuse

Always

Below 1 Ω

If the result is not as specified, replace the EFI No. 1 fuse.

(b) Measure the resistance of the EFI relay.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1C-1 - 1B-4

1C-1 - 1B-5

When battery voltage is not applied to terminals 1B-2 and 1B-3

10 kΩ or higher

When battery voltage is applied to terminals 1B-2 and 1B-3

Below 1 Ω

If the result is not as specified, replace the integration relay.

3. INSTALL INTEGRATION RELAY