Vehicle Interior
Sliding Roof ECU Power Source Circuit
DESCRIPTION
If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
READ VALUE USING TECHSTREAM (IGNITION SWITCH SIGNAL)
(a) Use the Data List to check if the ignition switch signal is functioning properly.
Click here  Sliding Roof
Tester Display | Test Part | Control Range | Diagnostic Note |
Ignition (MPX) |
Ignition switch signal (MPX signal)/ON or OFF |
ON: Ignition switch ON
OFF: Ignition switch off |
- |
Ignition (Direct Signal) |
Ignition switch signal/ON or OFF |
ON: Ignition switch ON
OFF: Ignition switch off |
- |
OK:
The Techstream displays as shown in the table according to the operation of each switch.
| OK |
 |
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)
(a) Disconnect the W3 ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
W3-9 (IG) - Body ground |
Ignition switch ON |
11 to 14 V |
W3-9 (IG) - Body ground |
Ignition switch off |
Below 1 V |
W3-10 (B) - Body ground |
Always |
11 to 14 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
W3-8 (E) - Body ground |
Always |
Below 1 Ω |
| OK |
 |
REPLACE SLIDING ROOF GLASS SUB-ASSEMBLY (SLIDING ROOF ECU) |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?