Vehicle Interior
Terminals Of Ecu
TERMINALS OF ECU
1. SLIDING ROOF DRIVE GEAR (SLIDING ROOF ECU)
(a) Disconnect the W3 ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
W3-1 (UP) - Body ground |
BR - Body ground |
Sliding roof switch signal |
TILT switch is pressed to up |
Below 1 Ω |
W3-1 (UP) - Body ground |
BR - Body ground |
Sliding roof switch signal |
TILT switch is not pressed to up |
10 kΩ or higher |
W3-2 (DWN) - Body ground |
W - Body ground |
Sliding roof switch signal |
TILT switch is pressed to down |
Below 1 Ω |
W3-2 (DWN) - Body ground |
W - Body ground |
Sliding roof switch signal |
TILT switch is not pressed to down |
10 kΩ or higher |
W3-6 (OPN) - Body ground |
BE - Body ground |
Sliding roof switch signal |
SLIDE switch is pressed to open |
Below 1 Ω |
W3-6 (OPN) - Body ground |
BE - Body ground |
Sliding roof switch signal |
SLIDE switch is not pressed to open |
10 kΩ or higher |
W3-7 (CLS) - Body ground |
V - Body ground |
Sliding roof switch signal |
SLIDE switch is pressed to close |
Below 1 Ω |
W3-7 (CLS) - Body ground |
V - Body ground |
Sliding roof switch signal |
SLIDE switch is not pressed to close |
10 kΩ or higher |
W3-8 (E) - Body ground |
W-B - Body ground |
Ground |
Always |
Below 1 Ω |
W3-9 (IG) - Body ground |
SB - Body ground |
IG power supply |
Ignition switch ON |
11 to 14 V |
W3-9 (IG) - Body ground |
SB - Body ground |
IG power supply |
Ignition switch off |
Below 1 V |
W3-10 (B) - Body ground |
L - Body ground |
+B power supply |
Always |
11 to 14 V |
If the result is not as specified, there may be a malfunction on the wire harness side. |
Was this page helpful?