Toyota Venza: Back Door Opener Switch

Components COMPONENTS ILLUSTRATION

Removal REMOVAL PROCEDURE

1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY

2. REMOVE REAR LIGHT ASSEMBLY LH

3. REMOVE REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side.

4. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

5. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY

(a) Remove the back door opener switch assembly.

Inspection INSPECTION PROCEDURE

1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY

(a) Check operation of the opener switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection	Switch Position	Specified Condition
2(E) - 3(UL)	Back door opener switch not pushed (OFF)	10 kΩ or higher
2(E) - 3(UL)	Back door opener switch pushed (ON)	Below 1 Ω

If the result is not specified, replace the back door opener switch assembly.

(b) Check operation of the lock switch (w/ Smart Key System).

(1) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection	Switch Position	Specified Condition
1(L) - 2(E)	Back door lock switch not pushed (OFF)	10 kΩ or higher
1(L) - 2(E)	Back door lock switch pushed (ON)	Below 1 Ω

If the result is not specified, replace the back door opener switch assembly.

Installation INSTALLATION PROCEDURE

1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

(a) Install the back door opener switch assembly.

2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

3. INSTALL REAR LIGHT ASSEMBLY LH

4. INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side.

5. INSTALL BACK DOOR PANEL TRIM ASSEMBLY

Back Door Opener Switch