Power Back Door Closer Switch

Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY

2. REMOVE POWER BACK DOOR CLOSER SWITCH ASSEMBLY

(a) Disconnect the connector.

(b) Disengage the 4 claws and remove the power back door closer switch assembly.

Inspection INSPECTION PROCEDURE

1. INSPECT POWER BACK DOOR CLOSER SWITCH

(a) Check that the switch function.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
4 - 1	Pushed (ON)	Below 1 Ω
4 - 1	Free (OFF)	10 kΩ or higher

Text in Illustration

*1	Component without harness connected (Power Back Door Closer Switch)

If the result is not as specified, replace the switch.

(b) Check that the switch illuminates. (1) Apply battery voltage to the power back door closer switch and check that the switch illuminates. OK: Measurement Condition Specified Condition Battery positive (+) → 3 (ILL+) Battery negative (-) → 2 (ILL-) Illuminates Text in Illustration *1 Component without harness connected (Power Back Door Closer Switch) If the result is not as specified, replace the switch.

Installation INSTALLATION PROCEDURE

1. INSTALL POWER BACK DOOR CLOSER SWITCH ASSEMBLY

(a) Engage the 4 claws to install the power back door closer switch assembly.

(b) Connect the connector.

2. INSTALL BACK DOOR PANEL TRIM ASSEMBLY