Toyota Venza Quiz
Door / Hatch

Power Back Door Warning Buzzer

In this manual: Door / Hatch
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE

1. INSPECT POWER BACK DOOR WARNING BUZZER

(a) Measure the resistance according to the value(s) in the table below.

HINT:

If battery voltage is applied directly to the buzzer, the buzzer will not sound.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (BZR-) - 2 (BZR+)

Always

950 to 1050 Ω
Text in Illustration

*1

Component without harness connected

(Power Back Door Warning Buzzer)

If the result is not as specified, replace the power back door warning buzzer.
Removal REMOVAL PROCEDURE

1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY


2. REMOVE POWER BACK DOOR WARNING BUZZER

(a) Disconnect the connector.

(b) Disengage the clamp to remove the power back door warning buzzer.

Installation INSTALLATION PROCEDURE

1. INSTALL POWER BACK DOOR WARNING BUZZER

(a) Engage the clamp to install the power back door warning buzzer.

(b) Connect the connector.

2. INSTALL BACK DOOR PANEL TRIM ASSEMBLY

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.