Toyota Venza Quiz
1ar-fe Engine Control

Removal

In this manual: 1ar-fe Engine Control
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL PROCEDURE

1. REMOVE WINDSHIELD WIPER MOTOR AND LINK

(a) Remove the windshield wiper motor and link (See page ).


2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


4. REMOVE COOL AIR INTAKE DUCT SEAL


5. REMOVE NO. 1 ENGINE UNDER COVER

6. REMOVE NO. 2 ENGINE UNDER COVER

7. DRAIN ENGINE COOLANT


8. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY


9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

(a) Disconnect the mass air flow meter connector and separate the wire harness clamp from the air cleaner cap.

(b) Separate the hose from the hose clamp.

(c) Disconnect the ventilation hose from the cylinder head cover.

(d) Unlock the hose band and separate the air cleaner cap sub-assembly from the throttle body assembly.

(e) Remove the 2 bolts and air cleaner cap sub-assembly.

10. REMOVE THROTTLE BODY ASSEMBLY

(a) Disconnect the throttle body assembly connector.

(b) Disconnect the fuel tube from the clamp.

(c) Disconnect the 2 water by-pass hoses from the throttle body assembly.

(d) Remove the 4 bolts and the throttle body assembly with the fuel tube bracket.

(e) Remove the bolt and fuel tube bracket.

(f) Remove the gasket from the intake manifold.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.