Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

6. REMOVE REAR DOOR SERVICE HOLE COVER

7. REMOVE REAR DOOR GLASS RUN

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

10. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the 3 screws.

(b) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(c) Remove the door lock wiring harness seal from the rear door lock assembly.

(d) Using a screwdriver, disengage the claw. HINT: Tape the screwdriver tip before use.

(e) Remove the rear door lock remote control cable assembly from the rear door lock assembly.

(f) Using a screwdriver, disengage the 3 claws. HINT: Tape the screwdriver tip before use.

(g) Remove the rear door inside locking cable assembly from the rear door lock assembly.