Room Temperature Sensor

Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR SCUFF PLATE LH

3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

5. REMOVE ROOM TEMPERATURE SENSOR

(a) Disengage the 2 claws and remove the room temperature sensor.

Inspection INSPECTION PROCEDURE

1. INSPECT ROOM TEMPERATURE SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	10 °C	3.00 to 3.73 kΩ
1 - 2	15 °C	2.45 to 2.88 kΩ
1 - 2	20 °C	1.95 to 2.30 kΩ
1 - 2	25 °C	1.60 to 1.80 kΩ
1 - 2	30 °C	1.28 to 1.47 kΩ
1 - 2	35 °C	1.00 to 1.22 kΩ
1 - 2	40 °C	0.80 to 1.00 kΩ
1 - 2	45 °C	0.65 to 0.85 kΩ
1 - 2	50 °C	0.50 to 0.70 kΩ
1 - 2	55 °C	0.44 to 0.60 kΩ
1 - 2	60 °C	0.36 to 0.50 kΩ

NOTICE:

• Hold the sensor only by its connector. Touching the sensor may change the resistance value.
• When measuring, the sensor temperature must be the same as the ambient temperature.

HINT:

As the temperature increases, the resistance decreases (see the graph).

If the resistance is not as specified, replace the room temperature sensor.

Text in Illustration

*1	Component without harness connected (Room Temperature Sensor)
*2	Sensing Portion

Installation INSTALLATION PROCEDURE

1. INSTALL ROOM TEMPERATURE SENSOR

(a) Engage the 2 claws to install the room temperature sensor.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

4. INSTALL FRONT DOOR SCUFF PLATE LH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).