Volkswagen Golf Quiz
Running gear, axles, steering

Balancing wheel, balancing wheel with finish balancer

In this manual: Running gear, axles, steering
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
010203040503022N·mlb·ft
Tightening torque found on this page

Note Before working with a finish balancer, the mechanic needs to have been instructed by the manufacturer of the balancer. To balance the wheels, set the wheels of the driven axle on the sensor platforms. On front-wheel drive models, front wheels must be set. On four-wheel drive models, all 4 wheels must be set. If you determine a residual imbalance greater than 20 grams when balancing the wheels, you should rotate the mounting position of the wheel on the hub.
  • Mark the point at which the imbalance is indicated.
  • Then, unbolt the wheel and rotate its position on the hub so that the marking points downwards.
Note

The hub must not rotate during this procedure.

  • First, hand-tighten the lowest wheel bolt to about 30 N·m.
  • Then, tighten the remaining wheel bolts diagonally to about 30 N·m. This process ensures that the wheel is centred properly on the hub.
  • Check whether the imbalance is less than 20 grams using the finish balancer.
Note The imbalance should always be less than 20 grams before you change the balance weight.
  • Loosen the wheel bolts again if necessary.
  • Rotate wheel again by 1 or 2 wheel bolt holes in relation to wheel hub.
  • Tighten wheels using the method described above.
Note Do not try to reduce the imbalance using balancing weights unless the imbalance is less than 20 grams.
  • Balance wheels if imbalance is less than 5 grams.
  • Tighten wheel bolts to specified torque if you have not already done so.
WARNING Always tighten wheel bolts to specified tightening torque using a torque wrench!

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.