Volkswagen Golf Quiz
Heating, air conditioning

Removing and installing air distribution flap control motor -V428-, RHD vehicles

In this manual: Heating, air conditioning
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~2min read

Special tools and workshop equipment required

Vehicle diagnostic tester

First carry out the following work:

  • Switch off all electrical consumers.
  • Switch off ignition.
  • Remove ignition key.

Removing

  • Remove glove compartment → General body repairs, interior; Rep. gr.68.
  • Remove bolts -2-.
  • Pull off front air distribution flap control motor -V426--1- and remove it.
  • Disconnect electrical connector -3-.

Installing

Installation is carried out in the reverse order. When installing, note the following: Note

Check operation of flaps and hinge mechanism before fitting.

Make sure levers and shafts are properly fitted in the mounts.
Removing and installing air distribution flap control motor -V428-, RHD vehicles
  • Receptacle of control motor -1- can be fitted on actuating arm -2- in only one position.
The receptacle of the control motor must align with the actuating arm as shown in illustration. Note Rotate the receptacle in the control motor if the mount and actuating arm do not align.
  • Switch on ignition, connect respective control motor to vehicle wiring harness and select a setting on operating and display unit to set control motor to desired position (e.g. mid-position). Wait until control motor has moved to desired position and switch off ignition.
  • Fit control motor on air intake box. The actuating arm must engage in receptacle -1--arrow- while doing so.
There must not be any play in the connection between control motor and actuating lever. Note If the bolts cannot be fitted, the control motor is not completely seated on the housing.
  • Route wiring harness so that it cannot come into contact with any moving parts (e.g. actuating arm on control motor).
Note Rotate control motor until it reaches a convenient position for installation. The direction of rotation can be changed by changing polarities.
  • Read event memory, and clear any entries displayed. Then, perform “basic setting”vehicle diagnostic tester in “Guided fault finding” mode.
  • As a final step, check operation of heater and air conditioning system.

Specified torque

→ Chapter „Assembly overview - heater and air conditioning unit“

Compartments/covers; Assembly overview - glove compartment → General body repairs, interior; Rep. gr.68.
Removing and installing air distribution flap control motor -V428-, RHD vehicles

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.