Volkswagen Golf Quiz
Heating, air conditioning

Removing and installing temperature flap control motor -V68-, LHD vehicles

In this manual: Heating, air conditioning
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~2min read

Heater and air conditioning system with electric/manual controls

Special tools and workshop equipment required

Vehicle diagnostic tester

Removing

  • Switch off ignition.
  • Equipment version with ignition lock: Remove ignition key.
Pyrotechnic components may trigger unintentionally.Risk of injury.Discharge any static charge accumulated in your body by briefly touching striker plate for door.
  • Remove footwell vent on driver side → Chapter.
  • Pull actuating lever -3- off heater unit.
Note

The upper bolt can be accessed with a commercially available ratchet.

  • Unscrew bolts -arrows-.
  • Disconnect electrical connector -2-.
  • Remove temperature flap control motor -V68--1-.
Removing and installing temperature flap control motor -V68-, LHD vehicles

Installing

Installation is carried out in the reverse order. When installing, note the following: Note

Check operation of flaps and hinge mechanism before fitting.

Make sure levers and shafts are properly fitted in the mounts.

  • Fit control motor -1- on air distribution housing. Gear wheel -2- on control motor must engage in the gear wheel -3- on actuating lever.

The long tooth -4- must engage in recess -arrow- on actuating lever.

Note If the gear wheels on the control motor and temperature flap lever do not align, rotate the receptacle in the control motor. If the bolts cannot be fitted, the control motor is not completely seated on the housing.
  • Switch on ignition, connect respective control motor to vehicle wiring harness and select a setting on operating and display unit to set control motor to desired position (e.g. mid-position). Wait until control motor has moved to desired position and switch off ignition.
  • Route wiring harness so that it cannot come into contact with any moving parts (e.g. actuating arm on control motor).
  • Read event memory, and clear any entries displayed. Then, perform “basic setting”vehicle diagnostic tester in “Guided fault finding” mode.
  • As a final step, check operation of heater and air conditioning system.

Specified torque

→ Chapter „Assembly overview - heater and air conditioning unit“
Removing and installing temperature flap control motor -V68-, LHD vehicles

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.