4- cylinder injection engine(1.4 1 direct inction. turbocharger)

Removing and installing oil pressure switch -F1-

~1min read

Special tools and workshop equipment required

Jointed wrench 24 mm -T40175-

Removing

Note

Fit all heat insulation sleeves in the original position when installing.

  • Remove noise insulation → General body repairs, exterior; Rep. gr.66.
Removing and installing oil pressure switch -F1-
  • Unscrew bolts -arrows- and remove heat shield for right drive shaft.
  • Remove heat-shield sleeve.
Removing and installing oil pressure switch -F1-
  • Disconnect electrical connector -arrow-.
Note

Place a cloth underneath to catch escaping engine oil.

  • Remove oil pressure switch -F1-.

Installing

Installation is carried out in the reverse order; note the following:

Note

The seal cannot be replaced individually.

If removed, oil pressure switch must be renewed.

Screw in new oil pressure switch -F1- immediately in hole to avoid loss of oil.

  • Check oil level → Booklet.

Specified torques

→ Chapter „Assembly overview - oil filter/oil pressure switch“

→ Running gear, axels, steering; Rep. gr.40

Removing and installing oil pressure switch -F1-

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.