Auxiliary heater
Testing quantity of fuel delivered
In this manual: Auxiliary heater
~1min read
Note Check fuel delivery rate as described in “Guided Fault Finding” function, vehicle diagnostic tester in “Guided Fault Finding” mode. Conditions for checking fuel delivery rate (in short):Coolant temperature below 30 °CAmbient temperature below 25 °CFuel tank sufficiently filled (needle on fuel gauge in dash panel insert is not in red zone)Battery -A- (vehicle battery) fully chargedFuel line (from fuel tank to auxiliary heater) installed according to specifications and filled completely with fuel Auxiliary heater installed completely and connected to vehicle electrical system All auxiliary heater fuses OK (according to current flow diagram) → Current flow diagrams, Electrical fault finding and Fitting locationsAuxiliary heater is switched offEvent memory of all self-diagnosis compatible systems read out; cause of any faults displayed in vehicle systems eliminated; displayed event memory entries erased, vehicle diagnostic tester in "Guided Fault Finding". Note A higher ambient or coolant temperature can lead to incorrect measurements of the fuel quantity delivered due to fuel evaporation. Complete description of conditions for checking fuel delivery rate vehicle diagnostic tester in “Guided Fault Finding” mode. If the quantity of fuel delivered is in the lower tolerance range and there are starting difficulties with the auxiliary heater, check the fuel lines to the auxiliary heater → Chapter. If no fault is found, renew the metering pump -V54- → Chapter.
|
Test yourself
A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?
Note Check fuel delivery rate as described in “Guided Fault Finding” function, vehicle diagnostic tester in “Guided Fault Finding” mode.