Undercoated areas

Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating.

Water drainage holes must remain clear.

All threaded studs and welded nuts with metric threads as well as all other studs and contact surfaces for assembly must be functional following the application of the undercoating.

Undercoating, detail view, front body

a -	Undercoating

Coat thickness: 0.3 mm

Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating.

Water drainage holes must remain clear.

All threaded studs and welded nuts with metric threads as well as all other studs and contact surfaces for assembly must be functional following the application of the undercoating.

Undercoating, detail view, rear body

a -	Undercoating

Coat thickness: 0.3 mm

b -	Undercoating

Coat thickness: 0.5 mm

Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating.

Water drainage holes must remain clear.

All threaded studs and welded nuts with metric threads as well as all other studs and contact surfaces for assembly must be functional following the application of the undercoating.

Undercoating, side member, with sectional view

1 -	Inner part of side member

2 -	Floor section

3 -	Side panel, exterior

b -	Undercoating

Coat thickness: 0.5 mm

Height -x- = 35 mm corresponds to thickness of 0,5 mm.

Height -y- = 10 mm decreasing thickness down to approx. 0.3 mm.

c -	Undercoating

Coat thickness: 1.2 mm

Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating.

Water drainage holes must remain clear.

All threaded studs and welded nuts with metric threads as well as all other studs and contact surfaces for assembly must be functional following the application of the undercoating.

Undercoating, rear body, front-wheel drive

1 -	Longitudinal member/rear wheel housing, vehicles with torsion beam rear suspension

2 -	Longitudinal member/rear wheel housing, vehicles with multi-link suspension

a -	Undercoating

Coat thickness: 0.3 mm

b -	Undercoating

Coat thickness: 0.5 mm

Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating.

Water drainage holes must remain clear.

All threaded studs and welded nuts with metric threads as well as all other studs and contact surfaces for assembly must be functional following the application of the undercoating.

Undercoating, rear underbody, 4-Motion vehicles

In the magnifying glass view the left longitudinal member/rear wheel housing is shown. The right side is the mirror image.

a -	Undercoating

Coat thickness: 0.3 mm

b -	Undercoating

Coat thickness: 0.5 mm