Brake system

Installation location overview

24steps
~144min
4/5difficulty
Done 0 of 24

ABS/ESP

VW UP. Bremsanlagen

  1. Control module for ABS -J104-
    • Installation location: on the hydraulic unit in the engine compartment, left, under the battery tray.
    • Do not disconnect the plug connection before self-diagnosis has been performed. Switch off the ignition before disconnecting the plug connection.

The following components are integrated in the control module:

  • Lateral acceleration sensor -G200-
  • Yaw rate sensor -G202-
  • Longitudinal acceleration sensor -G251- (depending on equipment)
Remove and install
  1. Hydraulic unit for ABS -N55-

The hydraulic unit consists of the following components:

Return pump for ABS -V39- Brake pressure sensor -G201- Valve block (contains the inlet/outlet valves) Return pump for ABS -V39- and valve block must not be separated from each other; remove and install
  1. Warning lamp for ESP and ASR -K155-
    • Installation location: in the instrument cluster insert
  2. Warning lamp for ABS -K47-
    • Installation location: in the instrument cluster insert
  3. Warning lamp for brake system -K118-
    • Installation location: in the instrument cluster insert
  4. Warning lamp for parking brake -K139-
    • Installation location: in the instrument cluster insert
  5. Brake light switch -F-
    • including brake pedal switch -F47-
    • Remove and install
  6. Switch for ASR and ESP -E256-
    • Installation location: in the center console
  7. Diagnostic connector
    • Installation location: driver footwell cover
  8. Steering angle sensor -G85-
    • Installation location: on the steering column between the steering wheel and the combination switch.
    • Observe installation instructions.
  9. Speed sensor front right/left -G45-/ -G47-
    • Remove and install
  10. Wheel hub with wheel bearing
    • the ABS sensor ring is installed in the wheel bearing.
  11. Speed sensor rear right/left -G44-/ -G46-
    • remove and install (drum brake)
  12. Wheel hub with wheel bearing
    • the ABS sensor ring is installed in the wheel bearing.

ABS

VW UP. Bremsanlagen

  1. Control module for ABS -J104-
    • Installation location: on the hydraulic unit in the engine compartment, left, under the battery tray.
    • Do not disconnect the plug connection before self-diagnosis has been performed. Switch off the ignition before disconnecting the plug connection.
    • Remove and install
  2. Hydraulic unit for ABS -N55-

The hydraulic unit consists of the following components:

Return pump for ABS -V39- Valve block (contains the inlet/outlet valves) Return pump for ABS -V39- and valve block must not be separated from each other; remove and install
  1. Warning lamp for traction control -K86-
    • Installation location: in the instrument cluster insert
  2. Warning lamp for ABS -K47-
    • Installation location: in the instrument cluster insert
  3. Warning lamp for brake system -K118-
    • Installation location: in the instrument cluster insert
  4. Warning lamp for parking brake -K139-
    • Installation location: in the instrument cluster insert
  5. Diagnostic connector
    • Installation location: driver footwell cover
  6. Brake light switch -F-
    • including brake pedal switch -F47-
    • Remove and install
  7. Speed sensor front right/left -G45-/ -G47-
    • Remove and install
  8. Speed sensor rear right/left -G44-/ -G46-
    • remove and install (drum brake)
  9. Wheel hub with wheel bearing
    • the ABS sensor ring is installed in the wheel bearing.
  10. Wheel hub with wheel bearing
    • the ABS sensor ring is installed in the wheel bearing.