Self Help

Introduction to the topic

~2min read
This chapter contains information on the following topics:

⇒ Information on replacing bulbs

⇒ Replacing bulbs in the headlight

⇒ Replacing the bulb in the front bumper

⇒ Replacing bulbs in the rear light

⇒ Replacing the bulb in the side turn signal

Replacing a bulb requires a certain degree of manual skill. Volkswagen therefore recommends having a bulb replaced by a Volkswagen Partner if you are unsure, or seeking other professional assistance. A specialist is always required if other vehicle parts must be removed in addition to the respective bulbs.

A kit with the replacement bulbs necessary for road safety should always be carried in the vehicle. Replacement bulbs are available from a Volkswagen Partner. In some countries, carrying these replacement bulbs is required by law.

Driving with failed exterior lights may be illegal.

Additional bulb specifications

Some bulbs in the headlights or rear lights may have specific factory specifications that differ from conventional bulbs. The corresponding designation is printed on the bulb base or the glass bulb.

LED lights

LEDs, e.g. in the license plate light, cannot be replaced by the customer. Seek professional help. Volkswagen recommends a Volkswagen Partner for this.

Additional information and warnings:
  • Exterior views ⇒ Exterior views
  • Lights and visibility ⇒ Lights and visibility
  • Preparations for working in the engine compartment ⇒ Preparations for working in the engine compartment
  • Vehicle tool kit ⇒ Vehicle tool kit
  • Fuses ⇒ Fuses
Warning
Accidents can be caused if the road is not sufficiently lit and the vehicle is not seen, or is only seen with difficulty, by other road users.

Warning

Improperly performed bulb replacement
can cause accidents and serious injuries.

  • Before carrying out any work in the engine compartment, always read and observe the warnings ⇒ Preparations for work in the engine compartment. The engine compartment of every vehicle is a hazardous area and can cause serious injuries.
  • H4, HB4 and H7 bulbs are under pressure and can burst when the bulb is changed.
  • Only replace the affected bulb once it has cooled down completely.
  • Never change a bulb unless you are familiar with the necessary procedures. If you are unsure what to do, have the work carried out by a qualified workshop.
  • Do not touch the glass bulb with bare fingers. Fingerprints left on the bulb evaporate when the light is switched on due to the heat and cause the reflector to fog up.
  • The headlight housing in the engine compartment and the housing of the tail light have sharp edges. Protect your hands when changing bulbs.
Note
If the rubber cover on the headlight housing is not installed correctly after a bulb change, damage to the electrical system can occur – mainly due to water ingress. Information on replacing bulbsFirst read and observe the introductory information
and safety warnings

⇒Introduction
to the topic