Self Help
Replacing bulbs in the front headlight
In this manual: Self Help
~1min read
Fig. 161In engine compartment: rear view of the
left front headlight with rubber cover: ① low beam and high beam, ② parking light and daytime running light, ③ turn signal light and retaining clip ④.
and safety warnings first⇒
to the topic
The front headlight does not need to be removed to change the bulbs.
| Carry out steps only in the order given: | |||
|---|---|---|---|
| ⇒ Fig. 161 | ① | ② | ③ |
| Low beam and high beam | Parking light and daytime running light | Front turn signal light | |
| 1. | Observe checklist and carry out steps ⇒ Information on changing bulbs. | ||
| 2. | Open the engine compartment lid for working in the engine compartment . |
||
| 3. | Disconnect the connector from the H4 bulb. Pull the rubber cover off the tabs. | Turn the bulb holder counterclockwise as far as it will go and pull it out to the rear with the bulb. | |
| Press retaining clip ④ forward in the direction of the arrow, unhook it to the side and fold it away. | |||
| 4. | Remove the bulb from the bulb holder. | ||
| 5. | Replace the failed bulb with a new bulb of the same type. | ||
| 6. | Insert the bulb, fold retaining clip ④ back and hook it in. | Insert the bulb holder into the headlight and turn it clockwise as far as it will go. | Insert the bulb holder into the headlight and turn it clockwise as far as it will go. |
| 7. | Fit the rubber cover and check that it is seated correctly. Plug the connector onto the H4 bulb. | ||
The illustrations show the left headlight from
behind. The right headlight is constructed as a mirror image.
Was this page helpful?