Self Help

Replacing the bulb in the front bumper

13steps
~78min
3/5difficulty
Done 0 of 13
Fig. 162

In front right wheel arch: unscrew fastening screws
(arrows) and remove expansion rivet Ⓐ.

Fig. 163

Replace the bulb in the headlight.


First read and observe the introductory information
and safety warnings

⇒Introduction
to the topic

  1. Observe checklist and carry out steps ⇒ Information on changing bulbs.
  2. Unscrew the 2 fastening screws of the wheel arch liner ⇒ Fig. 162 (arrows) with the screwdriver from the on-board tool kit ⇒ On-board tool kit.
  3. Unscrew the expansion rivet at the bottom front of the wheel arch liner ⇒ Fig. 162Ⓐ and remove it completely.
  4. Grasp the wheel arch liner at the edge between the holes of the loosened fastening screws and press it slightly toward the inside of the vehicle to release the clip behind it.
  5. Carefully fold the wheel arch liner to the side.
  6. Unlock and disconnect the connector ⇒ Fig. 163①.
  7. Turn the bulb holder ⇒ Fig. 163 in the direction of the arrow counterclockwise as far as it will go and pull it out to the rear with the bulb.
  8. Replace the failed bulb with a new bulb of the same type.
  9. Insert the bulb holder into the headlight and turn it clockwise as far as it will go.
  10. Plug the connector ⇒ Fig. 163① onto the bulb holder. The connector must click audibly into place.
  11. Fold the wheel arch liner back so that the clip behind it engages.
  12. Insert the expansion rivet into the wheel arch liner and bumper and press it in completely ⇒ Fig. 162Ⓐ.
  13. Tighten the 2 fastening screws ⇒ Fig. 162 (arrows) with the screwdriver.