Rear window washer system
Assembly overview - Rear window washer system

- Filler pipe with filler neck for washer fluid reservoir
- Remove and install
- Front and rear windshield washer pump -V59-
- Remove and install
- Washer fluid reservoir
- Remove and install
- Tightening torque, reservoir mounting bolt to body: 8 N·m
- Elbow connector
- Connection to front and rear windshield washer pump -V59-
- Connector
- Disconnect point, interior wiring harness to tailgate wiring harness
- Rear window washer jet
- in the high mounted brake light
- Remove and install
- adjust
Removing and installing washer jet
The rear window washer jet is installed in the high mounted brake light -M25-.
Removing
- Remove high mounted brake light -M25-.
- Release the two latches -arrows- and pull the washer jet -1- rearward out of the high mounted brake light -M25-.
Installing
- Installation is carried out in the reverse order.
- Adjust the washer jet.

Adjusting washer jet
Note
If the spray pattern is uneven due to contamination inside the washer jet, remove the washer jet and flush it with water against the spray direction. Subsequently blowing out against the spray direction with compressed air is permitted. Do not use any objects to clean the washer jets!
Adjusting rear window washer jets "Instandhaltung genau genommen".
Washer fluid lines
Repairing washer fluid lines
All instructions and notes for this chapter can be found under → Electrical system general information.