3-cyl. injection engine, timing belt drive (4-valve)

Crankcase Breather

5steps
~30min
2/5difficulty
0102030405097N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Assembly overview - Crankcase Breather

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

  1. Oil separator
    • Remove and install "Removing and installing oil separator"
    • Replace if damaged
  2. O-ring
    • replace after removal
    • Coat with oil before installation
  3. Hose
    • for crankcase breather
  4. Connector
    • Make sure positioning is correct
  5. Bolt
    • Self-locking
    • replace after removal
    • 9 N·m

Oil separator - tightening torque and sequence

- Tighten bolts in sequence -1 ... 9-.

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)


Removing and installing oil separator

Required special tools, testers and equipment, and auxiliary items

  • Commercially available sealant remover
  • Sealant → Electronic parts catalog

Removing


Note

Removing the throttle valve control unit -J338- is not necessary for this procedure!

- Remove intake manifold "Removing and installing intake manifold".

- Loosen and remove bolts in sequence -9 ... 1-.

- Carefully separate oil separator from the bonding.

Installing

Installation is carried out in the reverse order, observing the following:

Risk of damage to sealing surfaces. Carefully remove gasket residue from cylinder head and cylinder block. Make sure no long scratches or grooves are created.

- Thoroughly clean sealing surfaces on cylinder block and oil separator with commercially available sealant remover.

- Clean sealing surfaces of oil and grease.

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

- Screw 2 studs a few threads into holes -arrows-.


Note

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

Observe the shelf life of the sealant.

- Cut nozzle off at front marking (Ø of nozzle approx. 1.5 mm).

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

Risk of oil system blockage from excess sealant. Do not apply sealant bead thicker than specified.

- Apply sealant bead -arrow- to clean sealing surface of oil separator, as shown in illustration.

  • Thickness of sealant bead: 2 mm.

After applying sealant, install oil separator within 5 minutes.

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

- Place oil separator onto studs and position on crankcase.

- Unscrew studs.

- Tighten bolts in tightening sequence to specified tightening torque.

Install in reverse order, observing the following:

- Install intake manifold "Removing and installing intake manifold".

Tightening torques

  • Oil separator mounting bolts
  • Intake manifold mounting bolts "Removing and installing intake manifold"
VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)