Ford Mustang Quiz
Engine

Camshaft End Play - OHC Engines

In this manual: Engine
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read
1special tools

Special Tool(s)

 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent

1. Remove the roller followers. Refer to the appropriate section in Group 303 for the procedure.

2. Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.

3. Position the camshaft to the rear of the cylinder head.

4. Zero the indicator.

5. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.

  • If camshaft end play exceeds specifications, install new camshaft and recheck end play.

    Refer to the appropriate section in Group 303 for the procedure.

  • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head. Refer to the appropriate section in Group 303 for the procedure.
Camshaft End Play - OHC Engines

Camshaft -Lobe Surface

1. Inspect camshaft lobes for pitting or damage in the contact area. Minor pitting is acceptable outside the contact area.

  • If excessive pitting or damage is present, install new components as necessary. Refer to the appropriate section in Group 303 for the procedure.
Camshaft -Lobe Surface

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.