Hyundai Elantra CN7 Quiz

Rear Strut - Assembly

In this manual: Rear Strut - Assembly
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
0204060801005541N·mlb·ft
Tightening torque found on this page
1. Установите нижнюю проставку пружины так, чтобы выступы на ней были совмещены

1. Install the lower spring insulator so that its projections align with the holes in the lower spring seat.

2. Install the dust boot on the shock absorber.

3. С помощью специального инструмента (J38402, А-42) сожмите пружину.

3. Using the special service tool (J38402, A-42), compress the spring.

4. Выдвиньте шток амортизатора до упора, установите верхнюю чашку пружины и демпфируюущую

4. Fully extend the shock absorber piston rod, then install the upper spring seat and the strut mount assembly.

Align the flat part of the D-shaped hole in the upper spring seat with the flat on the unthreaded portion of the shock absorber piston rod.

5. Совместите верхний и нижнию витки пружины с соответствующими выемками на верхней

5. Align the upper and lower spring ends with the corresponding recesses in the upper and lower spring seats of the strut, then temporarily tighten the self-locking nut.

Replace the self-locking nut with a new one after removal.

6. При установке расположите демпфируюущую опору стойки так, чтобы ее болт был

6. During installation, position the strut damper mount so that its bolt is aligned with the projection of the upper spring seat, as shown in the illustration.

7. Remove the special service tools (J38402, A-20 and A-50).

8. Tighten the self-locking nut to the specified torque.

Tightening torque 40 - 55 N·m

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.