Hyundai Genesis DH Quiz
Engine Mechanical System

Cooling Fan Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
14steps
~84min
3/5difficulty
010203040507.86N·mlb·ft
Tightening torque found on this page
Done 0 of 14

Removal and Installation

Fan
  1. Disconnect the negative (-) battery cable from the battery.
  2. Remove the air cleaner assembly. (Refer to Air Intake and Exhaust System - "Air Cleaner").
  3. Disconnect the overflow hose (A) and the cooling fan motor connector (B).
  4. Loosen the cooling fan mounting bolts and remove the cooling fan (A).

    Tightening Torque: 4.9 ~ 7.8 N·m

  5. To install, reverse the removal procedure.
  6. Disconnect the negative (-) battery cable from the battery.
  7. Remove the air cleaner assembly. (Refer to Air Intake and Exhaust System - "Air Cleaner").
  8. Disconnect the cooling fan motor connector (A).
  9. Remove the cooling fan controller (PWM) (A).

    Tightening Torque: 4.9 ~ 8.3 N·m

  10. To install, reverse the removal procedure.
Cooling Fan Controller (PWM)

Disassembly

  1. Remove the rear cooling fan cover (A).

    Tightening torque: 1.8 ~ 2.4 N·m

  2. Remove the fan (B) from the cooling fan assembly (A).

    Tightening torque: 2.8 ~ 3.2 N·m

  3. Remove the cooling fan motor (A).

    Tightening torque: 3.9 ~ 5.9 N·m

  4. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.