Front Door Window Glass Repair Procedures

Replacement

1. 1
   Remove the front door trim. (Refer to Front Door - "Front Door Trim")
2. 2
   Loosen the mounting screws and remove the front door belt outside weatherstrip (A).

   

3. 3
   Separate the mounting plug hole cover (A) from the front door module. Lower the glass by pressing the window switch until the glass mounting bolt appears in the plug hole.
4. 4
   After loosening the mounting bolt (B) as far as possible and fully loosening bolt (C), tilt the front door glass (D) to lift it out upward.

   Tightening torque: 7.8 ~ 11.8 N·m

   

   Be careful not to drop the glass and/or scratch its surface.

   Using the door switch, align the mounting hole/bolt with the hole in the door. If the window regulator motor does not operate, remove the motor and align the hole manually.

5. 5
   Install in the reverse order of removal.

   Make sure the glass raises and lowers smoothly. If necessary, adjust the glass position. Check that the door locks and opens properly. Inspect the glass run channel for damage and replace it if damaged.