Hyundai Genesis DH Quiz
Steering

Steering Column and Shaft Repair Procedures

In this manual: Steering
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
22steps
~137min
5/5difficulty
1special tools
0204060801004936N·mlb·ft
Tightening torque found on this page
Done 0 of 22

Replacement

  1. Disconnect the negative battery cable from the battery and wait at least 30 seconds.
  2. Turn the steering wheel so that the front wheels are in the straight-ahead position.
  3. Remove the airbag module. (Refer to Restraint System - Driver Airbag Module (DAB) and Clock Spring)
  4. Disconnect the connector and the lock bolt (A), then remove the steering wheel using the special service tool (09561-11001).

    Tightening torque: 39.2 ~ 49 N·m
    Tighten the lock bolt properly and install the SST (09561-11001) to easily separate the steering wheel.
  5. Remove the steering column shroud. (Refer to Body (Interior and Exterior) - "Steering Column Shroud Panel")
  6. Remove the clock spring. (Refer to Restraint System - "Driver Airbag (DAB) Module and Clock Spring")
  7. Remove the multifunction switch. (Refer to Body Electrical System - "Multifunction Switch")
  8. Remove the lower crash pad panel. (Refer to Body (Interior and Exterior) - "Lower Crash Pad Panel")
  9. Remove the knee airbag and disconnect the connector.
  10. Loosen the steering column bolt (A) to disconnect the universal joint and steering gear connection.

    Tightening torque: 32.4 ~ 37 N·m

  11. Loosen the bolts (A) and (B) and remove the steering column assembly. Tightening torque: Nut: 12.7 ~ 17.7 N·m Bolt: 44.1 ~ 49 N·m
  12. Install in the reverse order of removal.
  13. Loosen the steering column bolt (A) to disconnect the universal joint and steering gear connection.

    Tightening torque: 32.4 ~ 37 N·m

  14. Loosen the nut (A) and remove the dust cover (B).

    Tightening torque: 32.4 ~ 37 N·m

  15. Raise the vehicle and make sure it is securely supported.
  16. Remove the lower cover (A), (B).
  17. Unscrew the inner universal joint bracket bolt (A) and remove the universal joint assembly.

    Tightening torque: 32.4 ~ 37 N·m

    [Left-hand drive]
    [Right-hand drive]
  18. Install in the reverse order of removal.
Universal Joint Assembly

Inspection

  1. Inspect the steering column for damage and deformation.
  2. Inspect the joint bearing for damage and wear.
  3. Inspect the tilt bracket for damage and cracks.
  4. Check the key lock operation and replace it if necessary.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.