Rear Driveshaft Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 107.9–128 N·m

   

3. 3
   Remove the driveshaft seal nut (A).

   Tightening torque: 274.6 - 294 N·m

   

4. 4
   Remove the trailing arm (A) from the rear carrier assembly. Tightening torque: Front: 98.1–118 N·m; Rear: 137.2–157 N·m

   

5. 5
   Remove the upper arm (A) after loosening the bolt and nut.

   Tightening torque: 137.2–157 N·m

   

6. 6
   Remove the auxiliary arm (A) after loosening the bolt and nut.

   Tightening torque: 137.2–157 N·m

   

7. 7
   Loosen the bolt and nut (A), then separate the rear lower arm assembly.

   Tightening torque: 137.2–157 N·m

   

8. 8
   Disconnect the driveshaft (A) from the rear carrier assembly.

   

9. 9
   Insert a pry bar between the differential housing and the joint housing, and separate the driveshaft from the differential carrier.

   

Inspection

1. 1
   Inspect the drive shaft boots for damage and wear.
2. 2
   Inspect the ball joint for wear and damage.
3. 3
   Inspect the splines for wear and damage.

   

4. 4
   Inspect the drive shaft for cracks and wear.
5. 5
   Inspect the TJ outer race, inner race, cage, and balls for rust or damage.
6. 6
   Check the BJ boot for water, foreign material, or rust.

   

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   Check the alignment. (Refer to Suspension System - "Alignment")