Maintenance

Brake fluid

~1min read

Checking Brake Fluid Level

Hyundai Palisade. Brake fluid

Check the fluid level in the reservoir periodically. The fluid level should be between the MAX and MIN marks on the side of the reservoir.

Before removing the reservoir cap and adding brake fluid, thoroughly clean the area around the reservoir cap to prevent contamination of the brake fluid.

If the level is low, add the specified brake fluid up to the MAX level. The level will drop as the brake pads wear with mileage. This is normal. If the fluid level is too low, have the brake system inspected by an authorized HYUNDAI dealer.

WARNING

If the brake system requires frequent fluid additions, this may indicate a leak in the brake system. Have the vehicle inspected by an authorized HYUNDAI dealer.

WARNING

Do not allow brake fluid to contact your eyes. If brake fluid contacts your eyes, flush them with clean water for at least 15 minutes and seek medical attention immediately.

NOTICE

  • Do not allow brake fluid to contact the vehicle body paint, as it will damage the paint.
  • Brake fluid that has been exposed to open air for an extended time must NEVER be used, as its quality cannot be guaranteed. It must be disposed of properly.
  • Do not use the wrong brake fluid. A few drops of mineral oil-based oil, such as engine oil, in your brake system may damage brake system components.

Information

Use only the specified brake fluid (see "Recommended Lubricants and Capacities" in Chapter 8).

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.