Hyundai Palisade Quiz
Body Electrical System

PTG spindle

In this manual: Body Electrical System
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
8steps
~48min
2/5difficulty
0102030405010.88N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the luggage compartment side trim. (Refer to Body - "Luggage Compartment Side Trim")
  3. Disconnect the PTG power spindle connector (A).
    Hyundai Palisade. Repair procedures
  4. Using a screwdriver, carefully lift the connector clips (A).
    Hyundai Palisade. Repair procedures
    Make sure not to close the tailgate while removing the spindle.
    Hyundai Palisade. Repair procedures
  5. If necessary, remove the nuts and replace the PTG spindle bracket (A).
    Hyundai Palisade. Repair procedures

Installation

  1. Connect the PTG spindle connector, then install the PTG spindle.

    Tightening torque: 6.9–10.8 N·m

  2. Install the tailgate trim and the luggage side trim.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.