Hyundai Tucson Quiz
Engine/Fuel Control System

Filler Neck Assembly Repair Procedures

In this manual: Engine/Fuel Control System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

DEPOSIT

  1. Open the fuel filler door, loosen the filler neck assembly mounting screw (A).
  2. Remove the left rear wheel, tire and inner fender cover from the wheel.
  3. Disconnect the filler neck hose (A) and the filler neck vent tube (B).
  4. Disconnect the quick connector from the level control hose (C).
  5. Remove the filler neck assembly from the vehicle after removing the mounting nuts from the bracket (A).

REMEDY

  1. To install, reverse the removal procedure. Filler neck bracket bolt: 7.8–11.8 N·m

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.