Engine/Fuel Control System
Fuel Tank Repair Procedures
In this manual: Engine/Fuel Control System
12steps
~72min
3/5difficulty
Done 0 of 12
DEPOSIT
- Release the residual pressure in the fuel line. (Refer to Fuel System - Repair Procedures - "Residual Pressure Release in Fuel Line")
- Remove the rear seat cushion (Refer to "SEAT" in group BD).
- Remove the fuel pump service cover (A).

- Disconnect the fuel pump control module connector (B).
- Disconnect the fuel pressure sensor (FPS) connector (B).
- Disconnect the quick connector (C) from the fuel supply hose.

- Raise the vehicle and support the fuel tank with a jack.
- Disconnect the filler neck hose (A).
- Disconnect the vent pipe (B).
- Disconnect the quick connector from the level control hose (C).

- Remove the lower cover (A) by removing the nuts.


- Remove the fuel tank from the vehicle after removing the fuel tank band (A).

REMEDY
- To install, perform the removal procedure in reverse order. Fuel tank strap mounting nut: 39.2 ~ 54 N·m
Test yourself
A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?