Hyundai Tucson Quiz
Engine/Fuel Control System

Fuel Line Repair Procedures

In this manual: Engine/Fuel Control System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
9steps
~54min
3/5difficulty
Done 0 of 9

DEPOSIT

  1. Release the residual pressure in the fuel line. (Refer to Fuel System - "Fuel Line Residual Pressure Release".)
  2. Turn the ignition switch to the OFF position, then disconnect the (-) battery cable.
  3. Disconnect the quick connector (A) from the fuel supply hose.
  4. Disconnect the vapor hose (A) connected to the PCSV.
  5. Raise the vehicle.
  6. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank".)
  7. Remove the breather tube and the fuel line clip (A) using a flat-tip screwdriver.
  8. Remove the lower side cover (A) after loosening the mounting bolts.
  9. Remove the fuel line (A) after loosening the clamps and mounting bolts.

REMEDY

  1. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.