Removal of Hardtop

Remove both front panels.

Open both front doors.

Using the supplied No. 50 Torx screwdriver and ratchet, remove the two Torx screws securing the hardtop to the center pillar (at the top of the front doors).

Step Three

Remove the six Torx screws securing the hardtop to the vehicle (along the inside of the body, three screws on each side) using the No. 50 Torx screwdriver.

Step Four

Fully open the swing gate to clear the rear window. Lift the rear window glass.

Step 5

Locate the wiring harness and washer hose in the left rear inner corner of the vehicle.

Step Six

Release the lock by pressing it down.

Step Seven

To disconnect the wiring harness, press the tab inward and pull downward to disconnect.

Step 8

Step 8

To remove the washer hose, press and hold the release button on the hose connector and pull downward.

Step 9

Secure the wiring harness to the body side by inserting it into the receptacle and re-engaging the locking tab.

Step 10

Secure the washer hose by inserting it into the receptacle at the top of the body side.

Step 11

Step 11

Lower the rear window and close the swing gate.

Remove the hardtop from the vehicle. Place the hardtop on a soft surface to prevent damage.