Installing the Soft Top

If installed, remove the hard top.

Install the door rails, starting with the front, then the rear on each side. For the procedure and applicable torque specifications for the door rail Torx screws, refer to the chart below.

Install the rear latches on each side of the rear of the vehicle using the supplied No. 50 Torx screwdriver and ratchet. Refer to the torque specifications table below for the recommended torque.

Step Three

Make sure the auxiliary lift mechanism is in the "LOCK" position, then lift the soft top at the rear of the vehicle with the side links pointing forward. Lower the auxiliary lift mechanisms onto the latches on both sides (on the inside of the sport bar).

Step Four

Step Four

Using the supplied No. 40 Torx screwdriver and ratchet, tighten the Torx screws by turning them clockwise. Tighten until snug (refer to the torque specifications table below for recommended torque), taking care not to cross-thread or overtighten the screws. Repeat on the opposite side.

Step 5

1. Lock Position
2. Torx Head Screw
3. Torx Head Screw

Pull the release lever at the top of the guide rearward, insert the side link into the guide at the top of the rail, then release the lever.

Step Six

Snap off and remove the black rear cover. This cover should be discarded. It is intended as a protective cover for shipping only.

Raise the soft top.

NOTE:

Make sure the wiring harness in the left rear corner is not caught in the soft top bows before raising the top.