Mode Control Actuator Repair Procedures

Inspection

1. 1
   Ignition switch OFF
2. 2
   Disconnect the mode actuator connector.
3. 3
   Make sure the mode control actuator operates in the defrost mode when 12 V is applied to terminal 3 and terminal 7 is grounded.
4. 4
   Check that the mode actuator operates in the vent mode when the polarity is reversed.

   

   1. - 2. - 3. Defrost mode 4. Sensor ground

   5. Feedback signal 6. 5 V (DC) 7. Vent mode

5. 5
   Check the voltage between terminals 4 and 5. Specification

   Door Position	Voltage (4-5)	Fault Detection
   Max. Cool	0.3 ± 0.15 V	Low voltage: 0.1 V or less
   Max. Heat	4.7 ± 0.15 V	High voltage: 4.9 V or more

   
   It transmits the current position of the actuator to the control unit.
6. 6
   If the measured voltage does not meet the specification, replace the mode actuator with a known good actuator and check for proper operation.
7. 7
   If the problem is resolved, replace the mode actuator.

Replacement

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the left side airbag cover (A).

   

3. 3
   Remove the console side cover [LH]. (Refer to Group BD - "Console")
4. 4
   Remove the lower emergency air bag cover (A) by loosening the mounting screws.

   

5. 5
   Disconnect the diagnostic connector (A) and remove the lower air bag cover.

   

6. 6
   Remove the left shower duct (A).

   

7. 7
   Remove the BCM (A) by loosening the mounting bolt and nut.

   

8. 8
   Disconnect the mode control actuator connector (A).
9. 9
   Loosen the mounting screw and remove the mode control actuator (B).

   

10. 10
    Installation is the reverse of removal.