Opening and Closing the Window

Enter

To open or close the window, press or pull up the front of the corresponding window switch to the first detent (5).

Type B: Window with Automatic Up/Down Function (if equipped)

Briefly press or pull up the power window switch to the second detent position (6) to fully lower or raise the window even after the switch is released. To stop the window at a desired position during operation, pull up or press down and release the switch.

✽ NOTICE

If the power window does not operate normally, the automatic power window system must be reset as follows:

1. Turn the ignition switch to the ON position.

2. Close the window and continue to pull up the power window switch for at least 1 second after the window is fully closed.

Automatic Reverse Function (for Type B windows, if equipped)

If upward movement of the window is blocked by an object or part of the body, the window will detect the resistance and stop moving up. The window will then lower approximately 30 cm (11.8 in.) so the object can be removed.

If the window detects resistance while the power window switch is continuously pulled up, the window will stop moving up and then lower approximately 25 mm (1 inch). If the power window switch is continuously pulled up again within 5 seconds after the window is lowered by the auto-reverse function, the auto-reverse function will not operate.

✽ NOTICE

The auto-reverse function is only active when the auto-up function is used by fully pulling the switch up. The auto-reverse function does not operate if the window is raised using a half-pressed power window switch.

WARNING

Always check for obstructions before raising any window to avoid injury or damage to the vehicle. If an object less than 4 mm (0.16 inch) in diameter is caught between the window glass and the upper window frame, the auto-reverse function may not detect resistance and will not stop or reverse direction.