Suspension System

Rear Shock Absorber Repair procedures

12steps
~72min
3/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Disconnect the battery negative cable.

  2. Remove the wheel nuts and tire.

    Tightening torque: 107.9 - 128 N·m

  3. Loosen the rear shock absorber bolts (A).

    Tightening torque: 58.8 - 74 N·m

  4. Loosen the nut (A) and then remove the rear shock absorber.

    Tightening torque: 98.0 - 118 N·m

  5. Install in the reverse order of removal.

Disassembly

  1. Remove the insulator cap (A).

  2. Loosen the lock nut (A).

  3. Install in the reverse order of removal.

Inspection

  1. Check the rubber parts for wear and deterioration.

  2. Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal

  1. Fully extend the piston rod.

  2. Drill a hole on the (A) section to remove gas from the cylinder.