Kia Stinger CK Quiz
Body (Interior and Exterior)

Front Seat Rear Cover

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
15steps
~90min
4/5difficulty
Done 0 of 15

Components and Component Location

Component Location

1. Front Seat Back Trim

Repair Procedures

Replacement

  1. Remove the front seat assembly.

    (Refer to Front Seat - "Front Seat Assembly")

  2. Remove the front seat extension cover (A).

  3. Remove the front seat outer cover (A) using a trim removal tool.

  4. Disconnect the front seat power switch connector (A).

  5. Remove the front seat inner shield cover (A) after loosening the screw.

  6. Raise the front seat headrest (A).

  7. Remove the front seatback lower cover (A).

  8. Remove the front seat back board (A).

  9. Remove the front seat ventilation duct (A) after loosening the screw.

  10. Disconnect the airbag connector (A) and the heater connector (B).

  11. Pull out and remove the headrest guides (A) after squeezing them on both sides at the lower part of the guides.

  12. Remove the protector (A) from the front seatback frame.

  13. Remove the front seat back trim (A) from the front seat back frame.

  14. Remove the front seatback trim (C) from the front seatback frame after removing the hook-and-loop fastener (A) and the ring clips (B).

  15. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.