Wipers

Operates as follows when the ignition switch is ON.

MIST: For a single wiping cycle, move the lever to this position (MIST) and release it. The wipers will operate continuously if the lever is held in this position.

OFF: The wiper does not operate.

INT: The wipers operate intermittently at set intervals. Use this mode in light rain or fog. To change the speed setting, turn the speed adjustment knob.

LO: Normal wiper speed

HI: Fast wiper speed

✽ NOTICE

If heavy snow or ice has accumulated on the windshield, defrost the windshield for approximately 10 minutes or until the snow and/or ice is removed before using the wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wipers and washer, it may damage the wiper and washer system.

Automatic Control

The rain sensor (A), located at the upper part of the windshield, detects the amount of precipitation and controls the wiping cycle at appropriate intervals. The heavier the rain, the faster the wiper operates. When the rain stops, the wipers stop.

To change the speed setting, turn the sensitivity adjustment knob (1).

If the wiper switch is set to the AUTO position with the ignition on, the wipers will operate once to perform a system self-check. Set the wiper to the OFF position when the wipers are not in use.

WARNING

When the ignition switch is ON and the wiper switch is in AUTO mode, observe the following precautions to avoid injury to your hands or other parts of your body:

• Do not touch the upper edge of the windshield facing the rain sensor.
• Do not wipe the upper edge of the windshield with a wet or damp cloth.
• Do not press on the windshield.

CAUTION

• When washing the vehicle, set the wiper switch to the OFF position to stop the automatic wiper operation. The wiper may activate and be damaged if the switch is set to AUTO while washing the vehicle.
• Do not remove the sensor cover located at the upper end of the passenger side windshield. Damage to system components may occur and may not be covered by your vehicle warranty.
• When starting the vehicle in winter, set the wiper switch to the OFF position. Otherwise, the wipers may activate and ice may damage the wiper blades. Always remove all snow and ice and defrost the windshield before operating the wipers.