Front Impact Sensor (FIS)

Description and Operation

Description

The Frontal Impact Sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration caused by a collision at their installation location. The main purpose of the Frontal Impact Sensor (FIS) is to determine collision. The FIS sends acceleration data to the SRSCM.

Components and Component Location

Component Location

Repair Procedures

Removal

1. 1

   Disconnect the negative battery cable.

2. 2

   Remove the Frontal Impact Sensor (A) by disconnecting the connector (B) and loosening the bolt.

   Tightening torque: 8.8–10.8 N·m

   [LH]

   

   [RH]

   

Installation

1. 1

   Install a new front impact sensor.

2. 2

   Tighten the front impact sensor mounting bolt.

   Tightening torque: 8.8–10.8 N·m

3. 3

   Connect the front impact sensor connector.

4. 4

   Install the radiator assembly.

5. 5

   Connect the negative battery cable.

6. 6

   After installing the Frontal Impact Sensor, verify that the system operates correctly:

   Turn the ignition ON; the SRS indicator should illuminate for about six seconds, then go off.