Rear Axle with Torsion Beam

Components and Component Location

Components

[Disc Type]

[Drum Type]

Repair Procedures

Replacement

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2. 2
   Remove the battery. G 1.0 MPI (Refer to Engine Electrical System — "Battery") G 1.2 MPI (Refer to Engine Electrical System — "Battery")
3. 3
   Disconnect the brake fluid level sensor connector.

   

4. 4
   Remove the brake fluid from the master cylinder reservoir using a syringe.
5. 5
   Remove the wheel tire (A).

   Tightening torque: 107.9–128 N·m

   

6. 6
   Remove the rear shock absorber cover.

   

7. 7
   Remove the rear shock absorber cover.

   

8. 8
   Remove the rear shock absorber nut using the special service tool (09546-3X100).

   Tightening Torque: 21.6–31 N·m

   

   

9. 9
   Unscrew the bolt and remove the rear shock absorber.

   Tightening torque: 98.0–118 N·m

   

10. 10
    Remove the rear caliper. (Refer to Brake System - "Rear Disc Brake") (Refer to Brake System - "Rear Drum Brake")
11. 11
    Remove the rear hub assembly. (Refer to Driveshaft and Axle - "Rear Hub - Carrier")
12. 12
    Remove the brake tube bracket bolt.

    

13. 13
    Loosen the nut (A) and clamp (B) on the rear torsion beam axle.

    

14. 14
    Loosen the rear torsion beam axle nut and remove the torsion beam axle.

    Tightening torque: 98.0–118 N·m

    

    

15. 15
    Install in the reverse order of removal.
16. 16
    After installation, bleed the brake system. (Refer to Brake System — "Brake System")