Mazda 2 Quiz
Standard Safety Equipment

Front Seats

In this manual: Standard Safety Equipment
Driving — 65Operation and maintenance — 45IN AN EMERGENCY — 45Interior comfort — 40Technical data — 4Customer Information — 9Getting to know your Mazda — 32Standard Safety Equipment — 24Your Vehicle - At a Glance — 12Fuel Requirements (SKYACTIV-G 1.3, SKYACTIV-G 1.5) — 1Fuel Requirements (SKYACTIV-D 1.5) — 1Emission Control System (SKYACTIV-G 1.3, SKYACTIV-G 1.5) — 1Emission Control System (SKYACTIV-D 1.5) — 1Engine Exhaust Emissions (Carbon Monoxide) — 1Replacing Exterior Light Bulbs — 1Replacing interior bulbs — 1
~2min read

Seat Adjustment

Regulacja siedzenia

  1. Sliding the Seat

To slide the seat forward or backward, pull up the lever, move the seat to the desired position, and release the lever.

Check that the lever has returned to its original position and that the seat is locked by trying to move it forward and backward.

  1. Height Adjustment (Driver's Seat)

The seat height can be adjusted by moving the lever up or down.

  1. Seatback Recline Adjustment

To change the seatback position, lean forward slightly and pull up the lever.

Then lean back to the desired position and release the lever.

Check that the lever has returned to its original position and that the seatback is locked by trying to tilt it forward and backward.

Seat Heaters*

The front seats are equipped with electric heaters. The ignition switch must be in the ON position.

When the ignition switch is in the ON position, the indicator light comes on when the seat heater button is pressed. Each time the button is pressed, the mode changes as shown below.

Ogrzewanie siedzeń*

WARNING

Use the seat heater with caution: The heater temperature may be too high for some people and may cause localized skin burns. This applies especially to:

  • Infants, small children, elderly people, and disabled people
  • People with sensitive skin
  • Tired people
  • Intoxicated people
  • People sleeping under the influence of sleep medication or cold tablets

Do not use the heater if the seat is covered with a moisture-absorbing material such as a blanket or cushion: The seat may overheat, causing localized skin burns.

Do not use the seat heater while sleeping in the car, even briefly.

The seat may overheat, causing localized skin burns.

Do not leave heavy objects with sharp edges on the seat, and do not stick needles or pins into it: This may cause the seat to overheat and cause minor skin burns.

CAUTION

Do not use organic solvents to clean the seat. They may damage the upholstery and the heating system.

CAUTION

  • If the ignition is switched off while the seat heater is operating (at high, medium, or low setting), the seat heater will automatically resume at the same temperature setting when the ignition is switched back on.

  • Use the seat heater only when the engine is running.

    Leaving the heater on for a long time with the engine off may drain the battery.

  • The seat heater temperature cannot be adjusted beyond the high, medium, and low settings, because the heating is controlled by a thermostat.

Test yourself

A quick Mazda 2 quiz: every answer comes with an explanation and a link to the manual page.