Mazda 6 Quiz
Automatic transaxle

Hold switch removal/installation

In this manual: Automatic transaxle
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
0204060801005440N·mlb·ft
Tightening torque found on this page

1. Disconnect the negative battery cable.

2. Remove the console.

3. Disconnect the connector and remove the HOLD switch terminals. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY.)

4. Remove the selector lever knob component.

5. Remove the HOLD switch.

6. Install the HOLD switch to selector lever knob component.

7. Install selector lever knob component.

Tightening torque 15.68-22.54 N·m {1.599-2.298 kgf·m, 12-16 ft·lbf}

8. Install the HOLD switch terminals and connect the connector.

9. Install the console.

10. Connect the negative battery cable.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.