Mazda 6 Quiz
Automatic transaxle

Input/turbine speed sensor removal/installation

In this manual: Automatic transaxle
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Disconnect the negative battery cable.

2. Remove the battery and battery tray.

3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)

4. Disconnect the input/turbine speed sensor connector.


5. Remove the input/turbine speed sensor.

6. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.

7. Install the input/turbine speed sensor.

Tightening torque 8-11 N·m {82-112 kgf·cm, 71-97 in·lbf}

8. Connect the input/turbine speed sensor connector.

9. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)

10. Install the battery and battery tray.

11. Connect the negative battery cable.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.