Mazda 6 Quiz
Automatic transaxle

Oil pressure switch removal/installation

In this manual: Automatic transaxle
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
0102030405011N·mlb·ft
Tightening torque found on this page
Warning
  • When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF.

1. Disconnect the negative battery cable.

2. Remove the under cover.

3. Disconnect the cord assembly connector.


4. Remove the oil pressure switch.

5. Install the oil pressure switch.

Tightening torque 17.1-22.1 N·m {1.75-2.25kgf·m, 13-16ft·lbf}

6. Connect the oil pressure switch connector.

7. Install the under cover.

8. Connect the negative battery cable.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.