Diagnosis Sensor Unit
Exploded View

| Diagnosis sensor unit | |||||
| : vehicle front | |||||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, in-lb) | |||||
Removal and Installation
Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). Refer to Precautions for Removing Battery Terminal.
Before disconnecting the air bag diagnosis sensor unit harness connector, be sure to disconnect each harness connector of the air bag modules, seat belt pre-tensioners and lap pre-tensioner to prevent air bag deployment by static electricity and seat belt pre-tensioner operation.
Never use air tools or electric tools for servicing (prevents the air bag diagnosis sensor unit from activating unexpectedly due to vibration).
When replacing the air bag diagnosis sensor unit, always check with the parts department for the latest parts information. Installing an incorrect air bag diagnosis sensor unit may or may not cause the air bag warning lamp to illuminate and may cause incorrect deployment of the supplemental air bags and seat belt pre-tensioners in a collision resulting in serious personal injury or death.
REMOVAL
Disconnect connector of all air bag modules, seat belt pre-tensioners, and lap pre-tensioners.
Driver air bag module: Refer to Removal & Installation.
Passenger air bag module: Refer to Removal & Installation.
Driver knee air bag module: Refer to Removal and Installation.
Passenger knee air bag module: Refer to Removal and Installation.
Front side air bag module: Refer to Removal & Installation.
Front center air bag module (with front center air bag module models): Refer to Removal & Installation.
Curtain air bag module: Refer to Removal & Installation.
Pre-tensioner seat belt: Refer to Removal & Installation.
Lap pre-tensioner: Refer to Removal & Installation.
Remove front center console assembly. Refer to Removal and Installation.
Remove AV control unit. Refer to Removal & Installation.
Disconnect diagnosis sensor unit harness connectors.
Remove diagnosis sensor unit mounting bolt and nuts, and then remove diagnosis sensor unit.
INSTALLATION
Note the following items, and then install in the reverse order of removal.