Restraints

Spiral Cable

~3min read

Exploded View

With ProPILOT Assist 2.1 models

Combination switch Steering angle sensor Spiral cable
: Pawl

Without ProPILOT Assist 2.1 models

Combination switch Steering angle sensor Spiral cable
: Pawl
: Always replace after every disassembly.

Removal and Installation

REMOVAL

Remove driver air bag module. Refer to Removal & Installation.

Remove steering wheel. Refer to Removal and Installation.

Remove steering column cover upper and lower. Refer to Removal and Installation.

Disconnect spiral cable body side harness connectors .

  • Left side

    : vehicle front
  • Right side

    (with steering heater models)

    : vehicle front

Disconnect steering angle sensor body side harness connector .

: vehicle front

Disengage spiral cable fixing pawls, and then remove spiral cable with steering angle sensor.

: Pawl

Remove steering angle sensor. Refer to Removal and Installation.

INSTALLATION

Set the neutral position.Carefully turn spiral cable clockwise to the end position.

Turn counterclockwise (about 2 and a half turns) and stop turning where the part of clear window appear yellow mark.

Install steering angle sensor to spiral cable. Refer to Removal and Installation.

Install spiral cable into combination switch by fixing pawls.

Remove lock pin of combination switch according to numerical order 1→2 indicated by arrows as shown in figure (without ProPILOT Assist 2.1 models).

Connect body side harness connectors to spiral cable and steering angle sensor.

Install steering column cover upper and lower. Refer to Removal and Installation.

Install steering wheel. Refer to Removal and Installation.

Install driver air bag module. Refer to Removal & Installation.