Restraints

Driver Air Bag Module

~2min read

Exploded View

Steering wheel Driver air bag module

Removal and Installation

  • Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). Refer to Precautions for Removing Battery Terminal.

  • Always work from the side of air bag module. Never work in front of it.

  • Never use the air tools or electric tools for servicing.

REMOVAL

From the hole on left, right, or lower of steering wheel, check the position of torsion spring secure the driver air bag module.

: vehicle front

Insert remover tool (A) into a hole of the steering wheel, and then press and disengage torsion spring .

: vehicle front

Remove remaining springs in numerical order from 1 to 3.

Disconnect driver air bag module harness connectors and horn switch harness terminal .

Remove driver air bag module.

INSTALLATION

Note the following items, and then install in the reverse order of removal.